Chrysler neon 1997 Service Manual page 1456

REVERSE IDLE GEAR CASE REVERSE GEAR SHAFT IDLE
PL
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 35 Reverse Idler Shaft Bolt Removal
Fig. 36 Reverse Idler Gear Removal
Fig. 37 Screws Retaining Reverse Fork Bracket
Verify shim spacers are in position on bench fixture.
Install transaxle into shop press.
INPUT SHAFT CASE REVERSE IDLE SHAFT IDLER SHAFT REVERSE BOLT SELECTOR FORK REVERSE BRACKET SHIFT REVERSE CAM SHIFT ASSEMBLY SHAFT SNAP RING PLIERS
SHIFT
(14) Install bearing fixture Miller tool #6768 onto
transaxle end bearings (Fig. 45). Verify tool is prop-
erly aligned to input and output shafts.
BLOCKOUT ASSEMBLY BLOCKER
BLOCKER
ASSEMBLY
Fig. 38 Remove Reverse Fork Bracket
Fig. 39 Remove Selector Shaft Spacer
Fig. 40 Selector Shaft
SELECTOR SPACER (PLASTIC) SHAFT
TRANSAXLE 21 - 13