Chrysler neon 1997 Service Manual page 1621

23 - 36 BODY
QUARTERPANEL
REMOVAL AND INSTALLATION (Continued)
(2) Remove screws holding door latch striker to
QUARTERPANEL
B-pillar (Fig. 51).
(3) Separate door latch striker from vehicle.
Fig. 51 Rear Door Latch Striker
INSTALLATION
Reverse the preceding operation.
REAR DOOR INTERLOCK LATCH STRIKER
REMOVAL
(1) Release door latch and open rear door.
(2) Mark outline of interlock striker on C-pillar to
aid installation.
(3) Remove interlock striker from vehicle (Fig. 52).
Fig. 52 Rear Door Interlock Latch Striker
INSTALLATION
Reverse the preceding operation.
FLOOR CONSOLE
REMOVAL
(1) Fully apply parking brake.
SHIM STRIKER
INTERLOCKSTRIKER
(2) Remove screw cover plugs over screws just
PRNDL SIDE ATTACHMENT COVER GEAR SELECTOR PARKING BRAKE ATTACHMENT CONSOLE COVER
rearward of cupholders.
(3) Remove screws holding console to floor bracket
just rearward of cupholders (Fig. 53).
(4) Open console storage compartment lid, if so
equipped.
(5) Remove screw cover plugs over screws near
rear of console, if vehicle is equipped with a non–ar-
mrest console.
(6) Remove screws holding console to floor bracket.
(7) Snap out side attachment covers, if equipped
(Fig. 53).
(8) Remove side attachment bolts holding rear of
console to floor bracket, if equipped.
(9) Remove shift lever knob, if vehicle is equipped
with a manual transmission.
(10) Lift console upward over gear selector and
park brake handle.
(11) Separate console from vehicle.
Fig. 53 Floor Console
INSTALLATION
(1) Move floor console into position in vehicle.
(2) Install screws holding console to floor brackets.
(3) Install screw cover plugs.
(4) Install side attachment covers, if equipped.
(5) Install shift lever knob, if vehicle is equipped
with a manual transmission.
(6) Release parking brake and close console stor-
age compartment lid, if so equipped.
DOOR SILL TRIM
REMOVAL
(1) Open door to gain access to sill trim.
PL