Chrysler neon 1997 Service Manual page 1625

SEAT BELT ANCHOR COVER
23 - 40 BODY
REMOVAL AND INSTALLATION (Continued)
FRONT OUTBOARD SEAT BELT
REMOVAL
(1) Slide lower seat belt anchor cover upward to
expose bolt.
(2) Remove bolt holding lower anchor bolt to floor
below door sill (Fig. 63).
(3) Separate lower anchor from floor.
(4) Remove rear seat cushion and back.
(5) Remove quarter trim panel.
(6) Guide seat belt webbing through slot in quarter
trim panel.
(7) Disengage wire connector from seat belt retrac-
tor.
(8) Remove bolts holding seat belt retractor to
B-pillar (Fig. 64).
(9) Separate seat belt retractor from vehicle.
Fig. 63 Front Outboard Seat Belt Anchor
INSTALLATION
Reverse the preceding operation. Tighten seat belt
anchor bolt to 39 N·m (29 ft. lbs.).
FRONT SEAT BELT BUCKLE
REMOVAL
(1) Move front seat to the forward position.
(2) Remove bolt holding seat belt buckle to seat.
(3) Separate seat belt buckle from seat.
INSTALLATION
Reverse the preceding operation.
FRONT SEAT BELT RETRACTOR
REMOVAL
(1) Remove B-pillar trim.
DOOR SILL ANCHOR BOLT SEAT TRACK B-PILLAR
SHOULDER BELT ADJUSTER B-PILLAR BELT RETRACTOR
Fig. 64 Front Outboard Seat Belt Retractor
(2) Remove bolt holding seat belt retractor to
B-pillar (Fig. 65).
(3) Separate seat belt retractor from vehicle.
Fig. 65 Front Seat Belt Retractor
INSTALLATION
Reverse the preceding operation.
FRONT SEAT BELT RETRAC-
LOWER ANCHOR TURNING LOOP
TOR
PL
TRIM KNOB COVER