Chrysler neon 1997 Service Manual page 1477

SELECTOR SHAFT
21 - 34 TRANSAXLE
DISASSEMBLY AND ASSEMBLY (Continued)
SHIFT CROSSOVER SHAFT
REMOVAL
(1) Disassemble transaxle using the procedure out-
lined in this group.
(2) With the transaxle disassembled, remove the
crossover shaft seal.
(3) Using snap–ring pliers, remove the snap ring
at the crossover shaft bore (Fig. 134).
Fig. 134 Crossover Shaft Snap Ring
(4) Push the crossover shaft in the case and
remove the crossover assembly.
INSTALLATION
(1) Reverse removal procedure to install crossover
shaft.
SHIFT SELECTOR SHAFT BUSHING
REMOVAL
(1) Remove selector shaft using procedure in this
group.
(2) Thread tool #6786 into bushing.
(3) Install slide hammer #3752 onto tool and
remove bushing using slide hammer (Fig. 135).
INSTALLATION
(1) Position replacement bushing over selector
shaft bore.
(2) Using an appropriate size deep–well socket,
install bushing in selector shaft bore (Fig. 136).
SHIFT CROSSOVER SHAFT BUSHING
REMOVAL
(1) Install slide hammer #3752 through the cross-
over bushing.
(2) Thread nut and washer onto slide hammer.
(3) Using the slide hammer, remove the crossover
shaft bushing (Fig. 137).
CROSSOVER S HAFT SNAP RING SLIDE HAMMER
Fig. 136 Selector Shaft Bushing Installation
INSTALLATION
(1) Position the replacement crossover shaft bush-
ing over the crossover shaft bushing bore.
C-3752
Fig. 135 Selector Shaft Bushing Removal
Fig. 137 Crossover Shaft Bushing Removal
SHIFTER SLIDE HAMMER BUSHING SHAFT WELL DEEP SOCKET SHIFTER SPECIAL SHAFT SHIFT BUSHING TOOL 6786 BUSHING SHAFT
PL