Chrysler neon 1997 Service Manual page 1344

PL
REMOVAL AND INSTALLATION (Continued)
(2) Unfasten clasps on top of air cleaner housing.
Rotate front of housing forward then lift front away
from air cleaner housing (Fig. 105).
Fig. 105 Removal/Installation Air Cleaner Front
Housing and Element
(3) Remove air cleaner element from front housing
(Fig. 105).
INSTALLATION
(1) Install air cleaner element into front housing.
(2) Rotate front of housing forward then lower into
place and locate tabs in slots. Fasten clasps on top of
air cleaner housing.
(3) Install air intake duct at air cleaner and intake
manifold.
ENGINE COOLANT TEMPERATURE SENSOR
The engine coolant temperature sensor threads
into the rear of the cylinder head (Fig. 106) or (Fig.
107).
REMOVAL
(1) With the engine cold, drain coolant until level
drops below cylinder head. Refer to Group 7, Cooling
System.
(2) Disconnect coolant sensor electrical connector.
(3) Remove coolant sensor.
AIR CLEANER
INSTALLATION
(1) Install coolant sensor. Tighten sensor to 18
N·m (165 in. lbs.) torque.
(2) Attach electrical connector to sensor.
(3) Fill cooling system. Refer to Group 7, Cooling
System.
Fig. 106 Engine Coolant Temperature Sensor—
Fig. 107 Engine Coolant Temperature Sensor—
FUEL SYSTEM
TEMPERATURE ENGINE POSITION CAMSHAFT COOLANT SENSOR SENSOR
FUEL RAIL
SOHC
DOHC
14 - 57
COOLANT TEMPER- ATURE SENSOR