Chrysler neon 1997 Service Manual page 1345

TRANSAXLE
14 - 58 FUEL SYSTEM
REMOVAL AND INSTALLATION (Continued)
VEHICLE SPEED SENSOR
The vehicle speed sensor is located in the transmis-
sion extension housing (Fig. 108).
REMOVAL
(1) Disconnect electrical connector from sensor.
(2) Remove the sensor mounting bolt.
(3) Lift the sensor out of the transaxle extension
housing. Ensure the O-ring was removed with the
sensor.
INSTALLATION
The speed sensor gear meshes with a gear on the
output shaft.
(1) With O-ring in place, install sensor.
(2) Install mounting bolt.
(3) Connect electrical connector to sensor.
Fig. 108 Vehicle Speed Sensor
SPEED SENSOR RETAINING BOLT SPEED SENSOR
KNOCK SENSOR
For removal/installation procedures refer to Group
8D- Ignition System, Service Procedures.
SPECIFICATIONS
VECI LABEL
If anything differs between the specifications found
on the Vehicle Emission Control Information (VECI)
label and the following specifications, use specifica-
tions on VECI label. The VECI label is located in the
engine compartment.
TORQUE SPECIFICATIONS
DESCRIPTION
Air Cleaner Wingnut . . . . . . . . . 1.5 N·m (15 in. lbs.)
Air Cleaner Mount. Stud-To-
Thrott. Body . . . . . . . . . . . . . 10 N·m (90 in. lbs.)
Crankshaft Position Sensor
Mounting Bolts . . . . . . . . . . . . 8 N·m (70 in. lbs.)
Engine Coolant Temperature
Sensor . . . . . . . . . . . . . . . . . 18 N·m (165 in. lbs.)
IAC Motor-To-Throttle Body
Bolts . . . . . . . . . . . . . . . . . . . . 7 N·m (60 in. lbs.)
MAP/IAT Sensor . . . . . . . . . . . . . 2 N·m (20 in. lbs.)
MAP/IAT Sensor . . . . . . . . . . . . . 3 N·m (30 in. lbs.)
Oxygen Sensor . . . . . . . . . . . . . . 28 N·m (20 ft. lbs.)
Powertrain Control Module
(PCM) Mounting Screws . . . . . 4 N·m (35 in. lbs.)
Throttle Body Mounting Bolts . 23 N·m (200 in. lbs.)
Throttle Position Sensor
Mounting Screws . . . . . . . . . . . 2 N·m (20 in. lbs.)
Vehicle Speed Sensor
Mounting Bolt . . . . . . . . . . . . 2.2 N·m (20 in. lbs.)
PL
TORQUE