Chrysler neon 1997 Service Manual page 1591

AND WINDSHIELD COWL A-PILLAR MOULD- INGS
23 - 6 BODY
REMOVAL AND INSTALLATION (Continued)
(19) Install inside rear view mirror.
(20) After urethane has cured, remove tape strips
and water test windshield to verify repair.
Fig. 3 Center Windshield and Mark at Support
Fig. 4 Work Surface Set up and Molding Installation
QUARTER GLASS
REMOVAL
(1) Remove quarter trim panel.
(2) Remove nuts holding quarter glass to quarter
panel opening.
(3) Remove B-pillar applique.
(4) Using a razor knife from inside of vehicle, cut
butyl tape adhesive around quarter glass while push-
ing outward on glass.
WINDSHIELD GLASS 7mm (.3 in.) FROM URETHANE BEAD AROUND MARKS BLOCKS EDGE
Spacers
SUPPORT SPACER WINDSHIELD OPEN- A-PILLAR FENCE
QUARTER PANEL
Fig. 5 Position Urethane Compression Spacers
Fig. 6 Lower Windshield Into Position
(5) Separate quarter glass from vehicle (Fig. 7).
INSTALLATION
(1) Clean old butyl tape adhesive from around
quarter glass opening in quarter panel.
(2) If original quarter glass is reused, clean old
butyl from around glass.
(3) Prime perimeter of quarter glass fence in quar-
ter panel opening with black-out primer.
ING ROOF PANEL SPACERS WINDSHIELD
QUARTER GLASS
Fig. 7 Quarter Glass
THANE APPLIED WITH REFERENCE URE- MARKS
PL