Chrysler neon 1997 Service Manual page 1506

PL
REMOVAL AND INSTALLATION (Continued)
IGNITION LOCK CYL-
INDER
Fig. 25 Upper/Lower Shroud
Fig. 26 Interlock Cable and Connector
(19) Remove interlock cable from under center con-
sole mounting bracket and out front of dash panel.
INSTALLATION
CAUTION: When installing interlock cable assem-
bly, care must be taken not to bend exposed cable
wire and slug at shifter end of cable.
(1) Route interlock cable into lower dash panel.
(2) Install the ignition switch into housing. Turn
the ignition switch to the RUN position.
(3) Install the interlock cable into the interlock
housing at the steering column (Fig. 27). Verify the
cable snaps into the housing.
INTERLOCK CABLE
within the wiring harness.
the shifter mechanism. Snap the shifter/ignition
interlock cable end fitting into the groove in the gear-
shift mechanism.
See Interlock System Adjustment, in this section.
operation check, as described in the beginning of this
section.
Body.
tor bezel and install bezel and indicator lamp.
column liner and lower left corner.
Install the three screws along the bottom of the lower
steering column cover and screw on the left outward
face of cover.
lower–to–upper shroud attaching screws through the
bottom of the lower shroud.
ing.
vehicle battery.
INTERLOCK SYSTEM ADJUSTMENT
position, with shifter in PARK, an adjustment of the
Interlock System may be required. To adjust Shifter/
Ignition Interlock System, follow procedure listed
below.
Fig. 27 Interlock Cable at Interlock Housing
(4) Install interlock cable into routing clip located
(5) Route interlock cable to the console.
(6) Install the cable core end to the plastic cam of
(7) Adjust the Shifter/Ignition Interlock System.
(8) Perform the Shifter/Ignition Interlock System
(9) Install console assembly. Refer to Group 23,
(10) Install screws retaining the gearshift indica-
(11) Install the gearshift knob set screw and knob.
(12) Install two screws at the upper area of the
(13) Snap the clips in at the lower column cover.
(14) Install key cylinder.
(15) Position the shrouds in place. Install the three
(16) Reinstall the ignition lock cylinder into hous-
(17) Reconnect the battery negative (-) cable to the
If ignition switch cannot be turned to the LOCK
TRANSAXLE 21 - 63