Chrysler neon 1997 Service Manual page 1619

INNER BELT REAR DOOR WEATHER- STRIP
23 - 34 BODY
REMOVAL AND INSTALLATION (Continued)
(7) Install screw behind inside latch release han-
dle.
(8) Install screw inside arm rest pull cup.
(9) Install window regulator crank.
REAR DOOR INNER BELT WEATHERSTRIP
REMOVAL
(1) Remove door trim panel.
(2) Pull weatherstrip from top of door panel (Fig.
46).
(3) Separate weatherstrip from door.
Fig. 46 Rear Door Inner Belt Weatherstrip
INSTALLATION
(1) Place inner belt weatherstrip in position on
door.
(2) Push down on weatherstrip to engage channel
to door panel.
(3) Install door trim panel.
REAR DOOR GLASS
REMOVAL
(1) Remove door trim panel and water shield.
(2) Remove inner door belt weatherstrip.
(3) Loosen door glass jounce bumper.
(4) Lower door glass to bottom of door.
(5) Remove nuts holding door glass to window reg-
ulator lift plate (Fig. 47).
(6) Disengage door glass from regulator.
(7) Lift door glass upward out of the opening at
the top of door.
INSTALLATION
(1) Lower door glass through opening in top of
door and into position in the window regulator.
(2) Install nuts holding door glass to window reg-
ulator lift plate.
VIEW A
REGULATOR LIFT PLATE
Fig. 47 Rear Door Glass
(3) Raise glass and tighten window inner belt sta-
bilizer.
(4) Install inner door belt weatherstrip, water-
shield, and door trim panel.
(5) Operate window and check for interference.
Adjust glass as necessary.
REAR DOOR WINDOW REGULATOR
REMOVAL
(1) Remove door trim panel and watershield.
(2) Remove door glass.
(3) Loosen bolts holding window regulator crank/
motor to door panel.
(4) Disengage bolt heads from keyhole slots in door
panel.
(5) Loosen bolts holding window regulator lift bar
to door panel. REAR DOOR
(6) Disengage bolt heads from keyhole slots in door
panel (Fig. 48).
(7) Remove window regulator from door through
access hole in inner panel.
Fig. 48 Rear Door Window Regulator
REAR DOOR GLASS
PL
WINDOW JACK SCREW REGULA- TOR