Chrysler neon 1997 Service Manual page 1339

SPEED CONTROL CABLE
14 - 52 FUEL SYSTEM
REMOVAL AND INSTALLATION (Continued)
Fig. 89 Transmission Kickdown Cable Connector
Fig. 90 Speed Control Cable Connector
(8) Compress the retaining tabs on the cable and
slide cable out of bracket (Fig. 88).
(9) Remove 2 screws holding cable mounting
bracket and support bracket.
(10) Remove TPS connector.
(11) Remove Idle Air Control motor connector.
(12) Remove EVAP purge hose.
(13) Remove throttle body mounting bolts. Remove
throttle body.
(14) The rubber O-ring gasket on the intake man-
ifold is reusable. Wipe the O-ring clean before install-
ing throttle body (Fig. 91).
INSTALLATION
(1) Install throttle body on intake manifold.
Tighten mounting bolts.
(2) Attach cable mounting bracket and support
bracket with 2 screws.
(3) Connect electrical connection to throttle body.
(4) Connect the EVAP purge hose.
(5) Install cable housing(s) retainer tabs into
bracket.
TRANSMISSION PUSH DOWN CABLE KICK- PUSH INTAKE MANIFOLD THROTTLE POSITION SENSOR
Fig. 91 Re-Usable Throttle Body Gasket
(6) Install throttle body cables using the following
procedures.
(7) From the engine compartment, rotate the
throttle lever forward to the wide open position and
install throttle cable clasp (Fig. 88).
(8) If equipped with speed control, rotate throttle
lever forward to the wide open position and slide
speed control cable connector onto nail head.
(9) Rotate throttle lever forward to the wide open
position and slide kickdown cable connector onto nail
head.
(10) Install throttle cable cover. Tighten bolt to 5.6
N·m (50 ins. lbs.).
THROTTLE POSITION SENSOR (TPS)
The throttle position sensor attaches to the side of
the throttle body (Fig. 92).
Fig. 92 Throttle Position Sensor and Idle Air Control
REMOVAL
(1) Disconnect EVAP purge hose from throttle body.
IDLE AIR CON- RE-USABLE
TROL MOTOR
Motor
GASKET
PL