Chrysler neon 1997 Service Manual page 1267

11 - 6 EXHAUST SYSTEM AND INTAKE MANIFOLD
REMOVAL AND INSTALLATION (Continued)
(6) Perform fuel system pressure release procedure
before attempting any repairs.
(7) Disconnect the fuel supply line quick connect at
the fuel tube assembly.
WARNING: WRAP SHOP TOWELS AROUND HOSE
TO CATCH ANY GASOLINE SPILLAGE.
(8) Remove fuel rail assembly attaching screws
and remove fuel rail assembly from engine. Cover
injector holes with suitable covering.
CAUTION: Do not set fuel injectors on their tips,
damage may occur to the injectors
(9) Remove clean air duct and upper air filter
housing (Fig. 13).
Fig. 13 Clean Air Duct to Throttle Body Assembly
(10) Remove accelerator, kickdown and speed con-
trol cables from throttle lever and bracket. Refer to
Group 14, Fuel System Throttle Body Removal for
procedures.
(11) Disconnect Idle Air Control (IAC) motor and
Throttle Position Sensor (TPS) wiring connectors
(Fig. 14).
(12) Disconnect vacuum hoses from throttle body
(Fig. 14).
(13) Disconnect Manifold Absolute Pressure/Intake
Air Temperature Sensor (TMAP), electrical connector
(Fig. 15). Disconnect vapor and brake booster hoses.
(14) Disconnect knock sensor electrical connector
(Fig. 16) and disconnect wiring harness from tab
located on the intake manifold.
(15) Disconnect wiring at starter.
(16) Remove transmission to throttle body support
bracket fasteners at the throttle body and loosen the
fastener at the transmission end.
(17) Remove throttle body.
MAP/AIR POSITION THROTTLE SENSOR PCV VACUUM NIPPLE INTAKE MANIFOLD TEMPERATURE SENSOR STARTER MOTOR
Fig. 14 Idle Air Control (IAC) Motor and Throttle
Position Sensor (TPS) Wiring Connectors and
Vacuum Hose Connection
Fig. 15 Intake Manifold Electrical and Vacuum Hose
Connections
Fig. 16 Knock Sensor
KNOCK SEN- SOR
IDLE AIR CON-
TROL MOTOR
PL