Chrysler neon 1997 Service Manual page 1605

COWL C OVER
23 - 20 BODY
REMOVAL AND INSTALLATION (Continued)
COWL COVER
REMOVAL
(1) Release hood latch and open hood.
(2) Remove windshield wiper arms, refer to Group
8K, Windshield Wiper and Washer Systems for
proper procedures.
(3) Remove push-in fasteners holding cowl cover to
cowl at base of windshield opening (Fig. 4).
(4) Separate cowl cover from vehicle.
Fig. 4 Cowl Cover
INSTALLATION
(1) Place cowl panel in place on vehicle.
(2) Install push-in fasteners holding cowl panel to
cowl at base of windshield opening.
(3) Install windshield wiper arms, refer to Group
8K, Windshield Wiper and Washer Systems, for
proper procedures.
FRONT DOOR TRIM—2 DOOR
REMOVAL
(1) Release door latch and open door.
(2) Lower door glass.
(3) Remove screw inside pull cup holding door trim
panel to bracket (Fig. 5).
(4) Pull and hold inside latch release handle away
from door trim.
(5) Remove screw holding trim panel to door from
behind inside door handle (Fig. 6).
(6) Remove window
equipped.
(7) Disengage hidden clips holding trim panel to
door from around perimeter of trim panel (Fig. 7).
(8) Tilt trim panel outward to clear locator pins on
backside of trim panel.
(9) Disengage trim panel from retainer channel on
inner belt weatherstrip at the top of the door by lift-
ing and gently jiggling.
(10) Move trim panel away from door and disen-
gage clip holding door latch linkage to back of inside
door handle.
COWL PUSH-IN FASTENER
regulator crank,
(11) Separate latch rod from handle.
CAUTION: Do not allow door trim panel to hang by
the wire connector or wiring.
(12) Disengage wire connector from power door
lock switch, mirror switch, and power window switch,
if so equipped.
(13) Separate trim panel from vehicle.
if so
Fig. 6 Inside Door Handle Screw
INSTALLATION
(1) Replace any damaged or missing push–in fas-
teners from around perimeter of door trim panel.
(2) Place trim panel near door.
(3) Engage wire connector to power lock switch,
mirror switch, and power window switch, if so
equipped.
(4) Insert latch rod into inside latch release.
Fig. 5 Front Door Pull Cup
PL