Chrysler neon 1997 Service Manual page 1475

DIFFERENTIAL BEARING BEARING RETAINER OUTPUT BEAR-
21 - 32 TRANSAXLE
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 126 Output Bearing Race Installation
Fig. 127 Input Bearing And Sleeve
(2) Press the input bearing out of the housing (Fig.
128).
INSTALLATION
(1) Apply coating of Loctite
outer diameter. Position sleeve and bearing assembly
at input bearing bore.
(2) Install tool #C-4680-1 over input bearing (Fig.
129).
ING TOOLC-4171 TOOLC-4628 OUTPUT BEAR- INPUT BEAR- ING RACE
sealant on bearing
ING TOOL C-4680-1 SPECIAL BELLHOUSING HALF SPECIAL TOOL 6342
Fig. 128 Input Bearing Removal
(3) Using the spacer tool #4894 and shop press,
install input bearing into bore until it is fully seated
(Fig. 130).
Fig. 129 Input Bearing Tool
Fig. 130 Input Bearing Installed
SPECIAL TOOL 4894 BELLHOUSING HALF INPUT BEARING AND BEARING SLEEVE AND ASSEMBLY SLEEVE
PL