Chrysler neon 1997 Service Manual page 1622

FRONT DOOR SILL DOOR OPENING TRIM START INSTALLATION
PL
REMOVAL AND INSTALLATION (Continued)
(2) Disengage clips holding sill trim to door sill
and door opening flange.
(3) Separate door sill trim from vehicle (Fig. 54).
Fig. 54 Door Sill Trim
INSTALLATION
(1) Position door sill trim on door sill.
(2) Align locating pins on backside of trim panel to
holes in door sill.
(3) Engage clips on trim panel into slots in door sill.
(4) Engage clips on trim panel onto door opening
flange.
(5) Press downward on trim panel to fully engage
all clips.
DOOR OPENING TRIM WELT
REMOVAL
(1) Open door to gain access to trim welt.
(2) Remove door sill trim panel.
(3) Pull trim welt from door opening flange (Fig. 55).
Fig. 55 Door Opening Trim Welt
INSTALLATION
(1) Locate paint dot on backside of trim welt.
(2) Position trim welt to vehicle with paint dot in
the appropriate position.
WELT REAR HERE DOOR SILL DOOR START TRIM WELT OPENING TION HERE INSTALLA- SILL TRIM
WINDSHIELD A-PILLAR
(3) Press trim welt onto door opening flange start-
ing at the paint dot position.
(4) Install door sill trim panel
A-PILLAR TRIM
REMOVAL
(1) Remove instrument panel top cover.
(2) Disengage clips holding trim to A-pillar.
(3) Separate A-pillar trim from vehicle (Fig. 56).
Fig. 56 A-pillar Trim
INSTALLATION
(1) Position A–pillar trim panel to A–pillar.
(2) Align locating pins on backside of trim panel to
mating holes in A–pillar.
(3) Push clips on trim panel into slots in A–pillar.
(4) Install instrument panel top cover.
SIDE COWL TRIM
COWL
REMOVAL
(1) Disengage clips holding cowl trim to cowl side
panel.
(2) Separate cowl trim from vehicle (Fig. 57).
Fig. 57 Side Cowl Trim
INSTALLATION
(1) Position cowl trim panel to inner cowl panel.
CLIPSA-PILLAR TRIM
BODY 23 - 37
SILL DOOR OPENING COWL TRIM