Chrysler neon 1997 Service Manual page 1492

PL
DIAGNOSIS AND TESTING (Continued)
CONDITION
SLIPS IN REVERSE
ONLY
SLIPS IN ALL POSITIONS
NO DRIVE IN ANY
POSITION
POSSIBLE CAUSES
1. Low reverse band misadjusted.
2. Hydraulic pressure too low.
3. Low reverse band worn out.
4. Valve body malfunction.
5. Low reverse band, servo or linkage
malfunction.
6. Low fluid level.
7. Incorrect gearshift linkage adjustment.
8. Faulty oil pump.
9. Aerated fluid.
10. Worn reaction shaft suppport seal
rings.
11. Worn front clutch.
1. Hydraulic pressure too low.
2. Valve body malfunction.
3. Low fluid level.
4. Oil filter clogged.
5. Faulty oil pump.
6. Worn input shaft seal rings.
7. Aerated fluid.
1. Hydraulic pressure too low.
2. Valve body malfunction.
3. Low fluid level.
4. Oil filter clogged.
5. Faulty oil pump.
6. Planetary gear sets broken or seized.
Diagnosis Guide
TRANSAXLE
CORRECTION
1. Adjust low reverse band.
2. Check fluid pressure at ports.
3. Replace low reverse band.
4. Inspect valve body and repair.
5. Repair low reverse servo. Adjust
reverse band and linkage.
6. Fill trans. to level.
7. Adjust gearshift linkage.
8. Replace oil pump.
9. Replace trans. fluid.
10. Replace reaction shaft support seal
rings.
11. Replace discs and seals at front
clutch.
1. Check fluid pressure at ports.
2. Inspect valve body and repair.
3. Fill trans. to level.
4. Replace oil filter.
5. Replace oil pump.
6. Replace input shaft seal rings.
7. Replace trans. fluid.
1. Check fluid pressure at ports.
2. Inspect valve body and repair.
3. Fill trans. to level.
4. Replace oil filter.
5. Replace oil pump.
6. Replace planetary gear sets.
21 - 49