Chrysler neon 1997 Service Manual page 1532

SCREW (2) SPECIAL L-4432 DIAL C-4658 TOOL AND INDICA-
PL
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 148 Checking Transfer Shaft End Play
STIRRUP AND STRAP INSTALLATION
Once bearing shim selection has been adjusted,
install stirrup and strap assembly onto transfer gear.
NOTE: Once the stirrup assembly is positioned
onto the transfer gear, it is necessary to "clock" the
stirrup against the flats of the transfer gear retain-
ing nut.
(1) Position the stirrup on the transfer gear.
(2) Position strap.
(3) Install retaining bolts into transfer gear. Fin-
ger–tighten bolts.
(4) Turn stirrup clockwise against the flats of the
transfer gear retaining nut.
(5) Tighten retaining bolts to 23 N·m (200 in. lbs.).
(6) Bend tabs of strap up against "flats"of retain-
ing bolts.
ASSEMBLY
To install transfer shaft, reverse the above proce-
dure.
TOR STEEL BALL (USE GREASE TO HOLD IN PLACE)
TRANSFER SHAFT GEAR
PIVOT SHAFT NOTE: SMALL DIAMETER TO PARKING SPRAG ROD SUP- PARKING
PARKING PAWL
DISASSEMBLY
Fig. 149 Parking Sprag Rod Support
Fig. 150 Support and Bolts
Fig. 151 Parking Pawl, Return Spring, and Pivot Shaft
PAWL REAR BOLT (2) PORT RETURN BOLT (2) SPRING
PARKING SPRAG ROD SUPPORT OUTPUT SHAFT GEAR
TRANSAXLE 21 - 89