Chrysler neon 1997 Service Manual page 1537

DIAL INDICATOR OUTPUT SHAFT SPECIAL NUT SPECIAL AND C-4658 OUTPUT SHAFT GEAR SCREW (2) WASHER L-4432 TOOL
21 - 94 TRANSAXLE
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 175 Holding Output Shaft Gear
Fig. 176 Tighten Output Shaft Retaining Nut to 271
N·m (200 ft. lbs.)
Fig. 177 Checking Output Shaft End Play
L-4438 TOOL SCREW(2) SCREW ( 2) STEEL (GREASE IN PLACE) SPECIAL TOOL L-4434 AND OUTPUT BALL L-4434 AND TOOL SPECIAL C-4658 C-4658 SHAFT GEAR
Fig. 178 Checking Bearing Turning Torque
STIRRUP AND RETAINING STRAP
INSTALLATION
Once bearing turning torque and shim selection
has been adjusted, install stirrup and strap assembly
onto output gear.
NOTE: Once the stirrup assembly is positioned
onto the output gear, it is necessary to "clock" the
stirrup against the flats of the output gear retaining
nut.
(1) Position the stirrup on the output gear.
(2) Position strap.
(3) Install retaining bolts into output gear. Finger-
–tighten bolts.
(4) Turn stirrup clockwise against the flats of the
output gear retaining nut (Fig. 179).
Fig. 179 Turn Stirrup Clockwise Against Flats Of
STRAP TURN STIRRUP CLOCKWISE
Retaining Nut
OUTPUT SHAFT GEAR TORQUE W RENCH
PL