Chrysler neon 1997 Service Manual page 1459

BENCH 6785 FIXTURE
21 - 16 TRANSAXLE
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 52 Reverse Brake Needle Bearing
Fig. 53 Reverse Brake Race
Fig. 54 Shift Blocker Removal
ASSEMBLY
The sealant used to seal the transaxle case halves
is Mopar Gasket Maker, Loctite 518, or equivalent.
BRAKERACE REVERSE BRAKE NEEDLE REVERSE BEARING BLOCKER SHIFT ASSEMBLY BENCH 6785 FIXTURE
The sealant used for the bearing end plate cover is
Mopar RTV.
(1) Verify bench fixture shims are removed from
bench fixture. Install output and input shafts into
bench fixture (Miller tool #6785) (Fig. 57).
(2) Install shift rails and forks into bench fixture
(Fig. 58).
(3) Install shift blocker assembly into bench fix-
ture (Fig. 59).
(4) Install reverse brake race onto input shaft (Fig.
60).
(5) Install reverse brake needle bearing (Fig. 61).
(6) Install reverse brake blocking ring (Fig. 62).
(7) Install reverse brake friction cone (Fig. 63).
(8) Install reverse brake shim (Fig. 64). Apply
petroleum jelly to shim to hold in place.
(9) Install gear–case half over bench fixture (Fig.
65). Line up shift finger over 3-4 lug.
(10) Line up reverse brake friction cone lugs to the
slots in the gear case (Fig. 66). Verify reverse brake
shim is in position.
BENCH 6785 FIXTURE 1–2 SHIFT FORK
Fig. 55 1–2 Shift Fork Removal
Fig. 56 Gear Train Removal
INPUT AND OUTPUT SHAFTS
PL