Chrysler neon 1997 Service Manual page 1606

HIDDEN CLIPS LOCATOR PIN FRONT DOOR FASTENERS DOOR TRIM
PL
REMOVAL AND INSTALLATION (Continued)
Fig. 7 Door Trim Panel
(5) Engage clip holding door latch linkage to back
of inside door handle.
(6) Engage trim panel into retainer channel at top
of door and push down to seat.
(7) Locate door trim panel to inner door panel by
aligning locating pins on backside of trim panel to
mating holes in inner door panel. Gently shift panel
forward or rearward if necessary.
(8) Engage hidden clips holding trim panel to door
from around perimeter of trim panel.
(9) With the window in the down position, orien-
tate the window regulator crank handle appropri-
ately. Install the right handle at the 10 o'clock
position and the left handle at the 2 o'clock position,
if so equipped.
(10) Install screw holding trim panel to door from
behind inside door handle.
(11) Install screw inside pull cup holding door trim
panel to bracket.
FRONT DOOR TRIM—4 DOOR
REMOVAL
(1) Release door latch and open door.
(2) Lower door glass.
(3) Remove window regulator crank, if so equipped
(Fig. 8).
(4) Remove screw from inside arm rest pull cup
(Fig. 9).
(5) Pull and hold inside latch release handle away
from door trim.
(6) Remove screw from behind inside latch release
handle (Fig. 9).
(7) Disengage push-in fasteners holding trim to
door panel around perimeter of trim panel.
(8) Tilt trim panel outward to clear locator pins on
backside of trim panel.
(9) Disengage trim panel from retainer channel in
inner belt weatherstrip at top of door by lifting while
gently jiggling.
(10) Move trim panel away from door and disen-
gage clip holding latch rod to handle.
(11) Separate latch rod from handle.
CAUTION: Do not allow door trim panel to hang by
the wire connector or wiring.
(12) Disengage wire connector from power door
lock switch, mirror switch, and power window switch
if so equipped.
(13) Separate trim panel from door.
LATCH RELEASE HANDLE
Fig. 8 Window Crank
Fig. 9 Front Door Trim
BODY
SCREW PULL CUP SCREW
23 - 21