Chrysler neon 1997 Service Manual page 1509

THROTTLE SHIFTER CABLE BRACKET PRESSURE CONTROL
CABLE BRACKET
21 - 66 TRANSAXLE
REMOVAL AND INSTALLATION (Continued)
Fig. 32 Shifter Cable Bracket
(7) Remove throttle pressure control cable from
lever. Then remove bracket bolts at the transaxle
(Fig. 33).
Fig. 33 Bracket Removal
(8) Remove dipstick tube.
(9) Remove transaxle cooler lines and plug lines
(Fig. 34).
(10) Remove throttle pressure control cable sup-
port bracket bolts. Remove upper bellhousing bolts
and upper starter bolt (Fig. 35).
(11) Install engine bridge fixture and support
engine (Fig. 36).
(12) Lift vehicle on hoist and remove front wheels.
(13) Remove both front driveshafts. Refer to Group
2, Suspension for procedure.
CAUTION: When reinstalling driveshafts, new drive-
shaft retaining clips must be used. Do not reuse old
clips. Failure to use new clips may result in disen-
gagement of inner constant–velocity joint.
(14) Remove transaxle to rear lateral bending
strut from engine and transaxle (Fig. 37).
COOLER FITTINGS STARTER BOLT LINE
Fig. 34 Cooler Lines
SUPPORT FIXTURE
Fig. 35 Starter and Bellhousing Bolts
Fig. 36 Engine Bridge Fixture
(15) Remove front engine bracket through–bolt.
Remove front engine bracket bolts (Fig. 38).
(16) Remove lower starter bolt (Fig. 39).
(17) Remove lower dust shield screw.
UPPER BELLHOUSING BOLTS
PL