Chrysler neon 1997 Service Manual page 1372

POWER STEERING POWER PUMP MOUNTING BRACKET STEERING MOUNTING POWER PUMP BOLTS MOUNTING BRACKET STEERING
PL
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 39 Pulley Removal From Power Steering Pump
Fig. 40 Power Steering Pump Mounting Bolts
CAUTION: Do not hammer on power steering
pump pulley or shaft to remove power steering
pump pulley. This will damage the pulley and the
power steering pump.
(2) Place power steering pump pulley squarely on
end of power steering pump shaft. Mount Installer,
Special Tool C-4063 in internal threads of the power
steering pump shaft and against power steering
pump pulley (Fig. 41).
(3) Ensuring that special tool and pulley remain
aligned with pump shaft, force pulley onto power
steering pump shaft until flush with the end of the
shaft (Fig. 42). When pulley is flush with shaft
tool will no longer be able to be turned.
(4) Remove Installer, Special Tool C-4063 from
power steering pump.
(5) Install power steering pump and bracket
assembly back on engine. Refer to Power Steering
Pump Installation in the Power Steering Pump Ser-
PUMP POWER STEERING PUMP PULLEY SPECIAL TOOL C-4333 OR POWER STEER- ING PUMP
Shaft
C-4068 POWER POWER STEER- PUMP BRACKET POWER ING PUMP STEERING STEERING
Fig. 41 Installing Pulley On Power Steering Pump
Fig. 42 Correctly Installed Power Steering Pump
vice Procedures section in this group of the service
manual for required procedure.
SPECIFICATIONS
POWER STEERING PUMP FLOW SPECIFICATIONS
Power Steering Pump Flow:
At 1500 RPM And Minimum
Pressure . . . . . . . . . . . . . . . . 4.9 to 5.3 Liters/Min
Control Valve Pressure
Relief . . . . . . . . . . . . . . . . . . . . 8240 to 8920 kPa
SHAFT PUMP SHAFT AS SHOWN TO CORRECTLY LEY MUST BE FLUSH WITH PUMP HUB OF POWER STEERING PUMP PUL- SPECIAL ING PUMP PUL- POWER C-4063 TOOL POWER
STEERING
Shaft
Pulley
(1.3 to 1.9 GPM)
(1195 to 1293 psi)
POSITION PULLEY WRENCH PUMP PULLEY STEER- WRENCH STEERING LEY
19 - 25