Chrysler neon 1997 Service Manual page 1470

PL
SPEEDOMETER STEEL STOCK DRIVE GEAR
DISASSEMBLY AND ASSEMBLY (Continued)
(1) Position speedometer drive gear onto differen-
tial assembly (Fig. 105).
Fig. 105 Speedometer Drive Gear
(2) Using Miller Tool # L-4440 and steel stock,
press speedometer drive gear onto differential (Fig.
106) (Fig. 107). Do not use a hammer.
Fig. 106 Press Gear onto Diferential
DIFFERENTIAL GEARS
NOTE: The plastic speedometer drive gear must be
removed from the differential case in order to ser-
vice the differential gears. Refer to Speedometer
Drive Gear for service information.
REMOVAL
(1) Remove pinion shaft retaining pin (Fig. 108)
(Fig. 109).
(2) Remove pinion shaft (Fig. 110).
(3) Rotate side gears to opening in differential
(Fig. 111).
(4) Remove differential gears (Fig. 112).
SPEEDOMETER DIFFERENTIAL ASSEMBLY DIFFERENTIAL SPECIAL ASSEMBLY PRESS DRIVE GEAR L-4440 TOOL RAM
DIFFERENTIAL ASSEMBLY
Fig. 107 Drive Gear Pressed onto Differential
Fig. 108 Remove Pinion Shaft Retaining Pin
Fig. 109 Retaining Pin Removed
INSTALLATION
(1) Assemble the differential side gears, pinion
gears and pinion gears with the pinion gear washers.
(2) Install pinion shaft retaining pin (Fig. 113).
TRANSAXLE 21 - 27
PINION SHAFT RETAINING SPEEDOMETER SPEEDOMETER RING GEAR PINION RETAINING PIN PIN DRIVE GEAR SHAFT DRIVE GEAR