Chrysler neon 1997 Service Manual page 1593

FLOOR PAN SEAT TRACK
23 - 8 BODY
REMOVAL AND INSTALLATION
CHILD RESTRAINT SEAT BACK
CHILD SEAT MODULE . . . . . . . . . . . . . . . . . . . 10
REMOVAL AND INSTALLATION
FRONT SEAT
REMOVAL
(1) Move seat to forward position.
(2) Remove bolts holding rear of seat track to floor.
(3) Move seat to rearward position.
(4) Remove bolts holding front of seat track to floor
crossmember (Fig. 1).
(5) Separate seat from vehicle.
Fig. 1 Front Seat
INSTALLATION
(1) Move seat to full rearward position and verify
that both seat tracks are locked into position.
(2) Move seat into position in vehicle. Do not use
the head restraint, side shield, recliner handle, or the
adjuster lift bar to move the seat.
(3) Ensure that the locating tabs on the front
mounting feet are installed through the slits in the
carpet and into the openings in the floor pan cross-
member.
FRONT SEAT
SEATS
INDEX
page
. . . . . . . . . . . . 9
seat track to floor crossmember.
seat track to floor crossmember.
track to floor.
NOTE: The torque specification for all front seat
retaining bolts is 55 N·M (40 ft. lbs.).
REAR SEAT CUSHION
REMOVAL
ion to disengage retainer loops from cups in floor.
2).
INSTALLATION
tom of seat back.
ion.
floor pan.
cushion to engage retainers.
RETAINER CLIPS
FRONT SEAT . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
REAR SEAT BACK . . . . . . . . . . . . . . . . . . . . . . . 9
REAR SEAT CUSHION
(4) Install and tighten front inboard bolt holding
(5) Install and tighten front outboard bolt holding
(6) Move seat to forward position.
(7) Install and tighten bolts holding rear of seat
(1) Pull upward at each end of the rear seat cush-
(2) Separate rear seat cushion from vehicle (Fig.
Fig. 2 Rear Seat Cushion
(1) Place rear seat cushion in position under bot-
(2) Position inboard seat belts on top of seat cush-
(3) Guide seat cushion loops into retainer cups in
(4) Push downward on the front corners of the seat
REAR SEAT CUSHION
page
. . . . . . . . . . . . . . . . . . . 8
PL