Chrysler neon 1997 Service Manual page 1449

SELECTOR CROSSOVER CABLE CABLE
21 - 6 TRANSAXLE
REMOVAL AND INSTALLATION (Continued)
Fig. 10 Selector Cable Removal
Fig. 11 Crossover Cable Removal
CAUTION: Pry up with equal force on both sides of
shifter cable isolator bushings to avoid damaging
cable isolator bushings.
(5) Remove cable to bracket retaining clips at tran-
saxle.
CAUTION: It is recommended that new cable retain-
ing clips be used for reinstallation.
(6) Pull cables up out of transaxle bracket.
(7) Remove console from vehicle. Refer to Group
23, Body.
(8) Remove floor pan grommet retaining nuts (Fig.
12).
(9) Remove cable retaining clips at shifter (Fig.
13).
CAUTION: It is recommended that new cable retain-
ing clips be used for reinstallation.
CROSSOVER LEVER SELECTOR LEVER SHIFT CABLE FLOOR GEARSHIFT GROMMET CABLES
GROMMET
(10) Disconnect shift cables from shifter. Pry with
equal force on both sides of shifter cable isolator
bushings to avoid damaging bushings.
(11) Lift vehicle on hoist. Remove self-tapping
screw securing grommet plate to underbody heat
shield and floor pan (Fig. 14).
(12) Detach cables from cable support clip in tun-
nel above exhaust catalyst.
(13) Remove shift cable assembly from vehicle.
INSTALLATION
CAUTION: Gearshift cable bushings must not be
lubricated or the bushings will swell and split.
(1) To install, reverse removal procedure. After
cables have been replaced, cable adjustment should
be checked. Refer to cable adjustment procedure in
this section.
SHIFT CABLE RETAINING
RETAINING
NUTS
Fig. 12 Grommet Retaining Nuts (Interior)
Fig. 13 Cable Retaining Clips
CLIPS FLOOR GROMMET PAN
PL