Chrysler neon 1997 Service Manual page 1614

JACK SCREW MIRROR STANCHION DOOR GLASS DOOR
PL
REMOVAL AND INSTALLATION (Continued)
SIDE VIEW MIRROR STANCHION
REMOVAL
(1) Remove side view mirror.
(2) Remove bolt holding top of side view mirror
stanchion to inner door panel.
(3) Remove bolts holding stanchion to outer door
panel (Fig. 33).
(4) Remove nut holding stanchion jack-screw to
inner door panel.
(5) Disengage push-in fastener holding door open-
ing weatherstrip to stanchion.
(6) Separate stanchion from vehicle.
Fig. 33 Side View Mirror Stanchion
STANCHION FRONT DOOR OUTER WEATHERSTRIP
Fig. 32 Side View Mirror
INSTALLATION
Reverse the preceding operation. Using a Snap-on
flare-nut socket (FRXM10) and hex-wrench adjust
the jack-screw at bottom of stanchion to achieve
proper alignment.
FRONT DOOR OUTER BELT WEATHERSTRIP
REMOVAL
(1) Open door glass.
(2) Pull upward at rear end of outer belt weather-
strip.
(3) Separate outer belt weatherstrip from vehicle
(Fig. 34).
BELT GLASS
Fig. 34 Outer Belt Weatherstrip—Typical
REAR DOOR
BODY 23 - 29