Chrysler neon 1997 Service Manual page 1305

DASHPANEL CABLE ASSEM- GROMMET BLY GROMMET CABLE ASSEM- RETAINER CLIP
14 - 18 FUEL SYSTEM
REMOVAL AND INSTALLATION (Continued)
(3) Attach vapor tube to valve.
(4) Install fuel filler tube cap.
ACCELERATOR PEDAL
CAUTION: When servicing the accelerator pedal,
throttle cable or speed control cable, do not dam-
age or kink the core wire inside the cable sheath-
ing.
REMOVAL
(1) Working from the engine compartment, remove
the throttle control shield.
(2) Hold the throttle body throttle lever in the
wide open position. Remove the throttle cable from
the throttle body cam.
(3) From inside the vehicle, hold up the pedal and
remove the cable retainer and throttle cable from the
upper end of the pedal shaft (Fig. 36) and (Fig. 37).
Fig. 36 Accelerator Pedal and Throttle Cable—Front
Fig. 37 Accelerator Pedal and Throttle Cable—Rear
DASH PANEL BLY SEAL PEDAL AND BRACKET CABLE RETAINER GROMMET
View
View
CABLE SHAFT THROTTLE MOUNTING SCREW MOUNTING TAB
(4) Working from the engine compartment, remove
nuts from accelerator pedal attaching studs (Fig. 36).
Remove assembly from vehicle.
INSTALLATION
(1) Position accelerator pedal assembly on dash
panel. Install retaining nuts. Tighten retaining nuts
to 12 N·m (105 in. lbs.) torque.
(2) From inside the vehicle, hold up the pedal and
install the throttle cable and cable retainer in the
upper end of the pedal shaft.
(3) From the engine compartment, hold the throt-
tle body lever in the wide open position and install
the throttle cable. Install the throttle control shield.
THROTTLE CABLE—MANUAL TRANSMISSION
REMOVAL
(1) Remove throttle control shield (Fig. 38).
(2) Working from the engine compartment, remove
the throttle cable from the throttle body lever (Fig.
39) and (Fig. 40).
(3) Compress the retaining tabs on the cable and
slide cable out of bracket.
(4) From inside the vehicle, hold the accelerator
pedal up and remove the cable retainer and cable
from upper end of pedal shaft (Fig. 36) and (Fig. 37).
(5) Remove retainer clip from throttle cable and
grommet at the dash panel.
(6) From the engine compartment, pull the throttle
cable out of the dash panel grommet. The grommet
should remain in the dash panel.
CONTROL SHIELD
Fig. 38 Throttle Control Shield
PL