Motorola MPC8260 PowerQUICC II User Manual page 296

Part III. The Hardware Interface
Figure 10-9 shows ORx as it is formatted for UPM mode.
Bit 0 1 2
Field
Reset
R/W
Addr 0x10104 (OR0); 0x1010C (OR1); 0x10114 (OR2); 0x1011C (OR3); 0x10124 (OR4); 0x1012C (OR5);
0x10134 (OR6); 0x1013C (OR7); 0x10144 (OR8); 0x1014C (OR9); 0x10154 (OR10); 0x1015C (OR11)
Bit 16 17 18
Field AM Ñ
Reset
R/W
Addr 0x10106 (OR0); 0x1010E (OR1); 0x10116 (OR2); 0x1011E (OR3); 0x10126 (OR4); 0x1012E (OR5);
0x10136 (OR6); 0x1013E (OR7); 0x10146 (OR8); 0x1014E (OR9); 0x10156 (OR10); 0x1015E (OR11)
Table 10-6 describes the ORx Þelds in UPM mode.
Table 10-6. Option Register (ORx)ÑUPM Mode
Bits Name
0Ð16 AM Address mask. Provides masking for corresponding BRx bits. By masking address bits
independently, external devices of different size address ranges can be used. Any clear bit masks
the corresponding address bit. Any set bit causes the corresponding address bit to be used in the
comparison with the address pins. Address mask bits can be set or cleared in any order in the Þeld,
allowing a resource to reside in more than one area of the address map. AM can be read or written
at any time.
17Ð19 Ñ Reserved, should be cleared.
19 BCTLD Data buffer control disable. Used to disable the assertion of BCTLx) during access to the current
memory bank. See Section 10.2.7, ÒData Buffer Controls (BCTLx)Ó.
0 BCTLx is asserted upon access to the current memory bank.
1 BCTLx is not asserted upon access to the current memory bank.
20Ð22 Ñ Reserved, should be cleared.
23 BI Burst inhibit. Indicates if this memory bank supports burst accesses.
0 The bank supports burst accesses
1 The bank does not support burst accesses. The UPMx executes burst accesses as series of single
accesses.
24Ð28 Ñ Reserved, should be cleared.
29Ð30 EHTR Extended hold time on read accesses. Indicates how many cycles are inserted between a read
access from the current bank and the next access.
00 Normal timing is generated by the memory controller. No additional cycles are inserted.
01 One idle clock cycle is inserted.
10 Four idle clock cycles are inserted.
11 Eight idle clock cycles are inserted.
31 Ñ Reserved, should be cleared.
10-20
3 4 5 6
0000_0000_0000_0000
19 20 21 22
BCTLD Ñ
0000_0000_0000_0000
Figure 10-9. ORxÑUPM Mode
MPC8260 PowerQUICC II UserÕs Manual
7 8 9 10 11
AM
R/W
23 24 25 26 27
BI Ñ
R/W
Description
12 13 14 15
28 29 30 31
EHTR Ñ
MOTOROLA