Table of Contents
Advertisement
Part IV. Communications Processor Module
The maximum sustained data rate that the SPI supports is SYSTEMCLK/50. However, the
SPI can transfer a single character at much higher ratesÑSYSTEMCLK/4 in master mode
and SYSTEMCLK/2 in slave mode. Gaps should be inserted between multiple characters
to keep from exceeding the maximum sustained data rate.
33.4 Programming the SPI Registers
The following sections describe the registers used in conÞguring and operating the SPI.
33.4.1 SPI Mode Register (SPMODE)
The SPI mode register (SPMODE), shown in Figure 33-4, controls both the SPI operation
mode and clock source.
Bit
0
1
2
Field
Ñ
LOOP
CI
Reset
0000_00
R/W
Addr
Table 33-1 describes the SPMODE Þelds.
Bits
Name
0
Ñ
Reserved, should be cleared.
1
LOOP Loop mode. Enables local loopback operation.
0 Normal operation.
1 Loopback mode. The transmitter output is internally connected to the receiver input. The receiver
and transmitter operate normally, except that received data is ignored.
2
CI
Clock invert. Inverts SPI clock polarity. See Figure 33-5 and Figure 33-6.
0 The inactive state of SPICLK is low.
1 The inactive state of SPICLK is high.
3
CP
Clock phase. Selects the transfer format. See Figure 33-5 and Figure 33-6.
0 SPICLK starts toggling at the middle of the data transfer.
1 SPICLK starts toggling at the beginning of the data transfer.
4
DIV16 Divide by 16. Selects the clock source for the SPI baud rate generator when conÞgured as an SPI
master. In slave mode, SPICLK is the clock source.
0 BRGCLK is the input to the SPI BRG.
1 BRGCLK/16 is the input to the SPI BRG.
5
REV
Reverse data. Determines the receive and transmit character bit order.
0 Reverse dataÑlsb of the character sent and received Þrst.
1 Normal operationÑmsb of the character sent and received Þrst.
6
M/S
Master/slave. Selects master or slave mode.
0 The SPI is a slave.
1 The SPI is a master.
33-6
3
4
5
6
CP
DIV16 REV
M/S
—
Figure 33-4. SPMODEÑSPI Mode Register
Table 33-1. SPMODE Field Descriptions
MPC8260 PowerQUICC II UserÕs Manual
7
8
9
10
EN
LEN
0_0000_0000
R/W
0x11AA0
Description
11
12
13
14
15
PM
MOTOROLA
Advertisement
Table of Contents
