Printing The Lj2D Font Status Sheet - Xerox 4213 User Manual

Printing the LJ2D font status sheet

Reading the LJ2D font status sheet
XEROX 4213 LASER PRINTER USER GUIDE
Make sure the display reads EMULATION/LJ2D*, then use the
display to select your desired language translation table.
the Online button to put the printer online (so your table choice
will take effect), then press the button again to take the 4213 off
line. Next press the Test/[Down Arrow] button to access the
Test Menu. Press the Last Page/[Right Arrow] button to display
TEST MENU/FONT STATUS.
print the font status sheet. After the pages are printed, press the
Online button to put the printer online again.
The LJ2D Font Status Sheet (refer to figure 4-4) lists all the fonts
that are currently loaded and available for use with the emulation:
The font number is assigned by the printer to each font set.
•
A font is selected through the menu by its unique font
number.
Fonts are grouped on the status sheet according to their font
•
source. Fonts are listed in the following order:
—Permanent soft fonts, if present
—Left or Right Cartridge fonts, if present
—Internal fonts.
Note: You will not erase permanent soft fonts from memory by
configuring LJ2D settings.
remain in the memory until the printer is turned off.
The status sheet reports the following information for each font
listed:
The font number:
•
A font is selected through the menu by its unique font
number.
The symbol set: Table 4-2 lists the possible symbol sets.
•
Pitch: Denotes the number of characters per inch.
•
spacing is designated
designated by P.
PRINTING WITH THE 4213
Now press the Select/[*] button to
Generally, permanent soft fonts
Assigned by the printer to each font set.
by F. Proportional
Press
Fixed
spacing is
4-11