Xes Emulation Items - Xerox 4213 User Manual

XES emulation items

XEROX 4213 LASER PRINTER USER GUIDE
The following section describes the XES emulation menu items
and their corresponding options.
Note: Below each description
is an example of the message display with the factory default for
the item written in boldface type followed by an asterisk.
options for each menu item are listed in parentheses following
the example of the message display.
disabled is the factory default for 2-sided print mode:
2-SIDED
DISABLED* (DISABLED, BOOK BINDING, or PAD BINDING)
An asterisk does not appear for numeric entries, such as, the
COPIES, FONT SELECT, or OVERRIDE FORMAT MARGINS.
Number of Copies
The Number of Copies menu item selects the number of copies
for each page printed.
printed, use this menu to select the number of copies required.
This would normally be a temporary change, and not saved to
memory.
Note: The printer does not collate the copies.
The Number of Copies menu item options are listed below as
they appear on the message display:
COPIES 01 (01 to 99)
Note: Most application software automatically sends a reset
printer command before the start of each job.
printer clears the memory of the printer and makes sure that the
number of copies is set to the previously saved default, usually
one.
Tray Sequence
The Tray Sequence menu item allows you to switch automatically
to another tray when the active tray is empty.
Sequence menu item selects the order in which trays are used as
the paper source. For example:
Single tray selection: Paper is fed from one tray only.
•
USING THE 4213 MENUS
of the emulation submenu item
In the following example,
When you want more than one copy
The
Resetting the
The Tray
3-23