Printing On Envelopes - Xerox 4213 User Manual

PRINTING WITH THE 4213

Printing on envelopes

4-28
A skewed image is usually the result of:
The sheet not being flush against the left feed guide when it
•
is inserted into the bypass slot
The sheet not being held in place at the bypass slot entrance
•
when it began to move through the bypass slot.
Note: The maximum size of paper which can be manually fed is
216 by 279 mm (8.5 by 14 inches). The minimum size is 99 by
191 mm (3.88 by 7.5 inches).
other than A4 or legal size paper while using manual feed or a
paper jam could occur.
Addresses are formatted to print on standard sized envelopes. In
the LJ2D emulation, you can select one of the standard
envelopes listed in table 4-5 using the PAPER SIZE menu item. In
the other emulations, you must format your pages for the
envelopes you are using before you submit your print job.
Envelopes are printed in the landscape orientation.
The address is placed on the envelope, according to the size of
the envelope being fed.
tray. Refer to "Selecting the bypass tray at the printer," section
shown earlier in this chapter for information on how to select the
bypass tray at the Main Menu.
You can set the envelope size in one of three ways:
If your application software allows you to select the envelope
•
size, the selected paper size command is automatically sent
to the printer and the image is placed in the correct location
on the envelope.
You can access the LJ2D emulation configuration in the Main
•
Menu and select one of the standard sizes listed in table 4-5
from the LJ2D paper size options. Refer to the next section,
"Setting the envelope size at the LJ2D sub-menu."
You can send a printer command, or an escape sequence, to
•
let the printer know the envelope size you are using.
to the LJ2D or XES section in the Rank Xerox 4213 Laser
Printer Programmer
formatting commands.
Do not try to 2-sided anything
Envelopes are printed using the bypass
Reference for information
XEROX 4213 LASER PRINTER USER GUIDE
Refer
on page