Resetting The Lj2D Emulation Configuration - Xerox 4213 User Manual

XEROX 4213 LASER PRINTER USER GUIDE
1. There are two ways to exit the Main Menu:
A Press the Menu button until OFF LINE appears in the
•
message display.
or
H Press the Online button.
•
green online indicator light is lit.)
H Press the Online button again to take the printer off line.
(The green online indicator light is not lit.)
Use the following buttons to save your selections as the LJ2D
default configuration:
G 2. Press the Reset button to access the Reset Menu.
display reads:
RESET MENU
EMULATION RESET
C 3. Press the Last Page button until the display reads:
RESET MENU
SAVE DEFAULTS
D 4. Press the Select button to save the emulation configuration
as the default configuration.
H 5. Press the Online button to put the printer back online. (The
green online indicator light is lit.)
Note: Changes to the emulation configuration are not in effect
until you place the printer online.
DEFAULTS option to save any changes made to the emulation
configuration settings, if you wish these settings to be permanent
and active each time the system is switched on.
when your system is switched off and then on again, the system
configuration returns to the configuration that was previously
saved.

Resetting the LJ2D emulation configuration

Resetting the printer clears the memory of the printer and
ensures that the emulation configuration defaults last saved are in
place at the beginning of each job.
Note: Most application software automatically sends a reset
printer command before the start of each job.
USING THE 4213 MENUS
The printer is online.
You must use the SAVE
Otherwise,
(The
The
3-35