Setting Different Options Under The Ibm Main Menu For Coax - Xerox 4213 User Manual

XEROX COAX/TWINAX OPTION

Setting different options under the IBM Main Menu for Coax

A3-42
Note: Initialising the Coax option by pressing the online button
to put the 4213 back online will restart the host communication
and reload the configuration option with Coax configuration
defaults.
To change the IBM Coax interface configuration, follow steps 1
to 7 in the previous section to access the heading IBM Main
Menu.
1. When the IBM Main Menu is displayed, the following buttons
on the control panel are used to move through the different
menu levels:
B Use the Test button to move to the next lower menu
•
level.
C Use the Last Page button to move the display to the right
•
to display the menu headings/options at the same level.
When you display the last heading/option available for
the menu item, pressing this button again will wrap
around to display the first heading/option in the list.
D Use the Select button before you initiate changes to
•
numeric entries, such as, TOP MARGIN, LEFT MARGIN,
PAGE LENGTH, PAGE WIDTH, and IRQ TIMEOUT.
A Use the Menu button to move to the next higher menu
•
level.
D Use the Select button to select a displayed option.
•
When an option is selected, an asterisk (*) appears next
to the option in the display.
Notes: The asterisk does not appear when Select is
pressed to select numeric entries, such as, TOP MARGIN,
LEFT MARGIN, PAGE LENGTH, PAGE WIDTH, and IRQ
TIMEOUT.
The control panel will allow you to select values beyond
the acceptable range for certain options.
out of range parameters, they will be ignored.
maximum allowed value for that parameter will be used
instead.
If you select
XEROX 4213 LASER PRINTER USER GUIDE
The