Xerox 4213 User Manual page 354

Number Message
1419 XES formatting error
1420 Initialisation error
1421 Software error
1422 Set up parser error
1423 Protocol error
1424 Non-volatile RAM error
1425 Multiple errors occurred.
1511 Power up
indicate a fault with the Co-
Ax/Twin-Ax interface.
XEROX 4213 LASER PRINTER USER GUIDE
Table A3-3. IBM Error Codes (continued
Meaning/action
An inconsistency has occurred in translating the data stream
into XES.
appearance of presented information.
An inconsistency has occurred during initialisation.
of subsequent operations may be unreliable.
A software inconsistency has been detected.
subsequent operations may be unreliable.
An invalid set up command has been detected in the host
data stream.
An inconsistency has been detected at the protocol level.
An invalid checksum was detected in the non-volatile
memory. All settings have been reset to factory defaults.
Some error reports have been lost.
diagnostic tests Power off.
installed correctly. Then, power back on. If fault continues
to occur, replace the PWB and cartridge.
This may result in loss of text and/or change in
Check that the PWB and the cartridge are
XEROX COAX/TWINAX OPTION
Results
Results of
A3-83