XEROX COAX/TWINAX OPTION
Using the IBM Coax interface
IBM Main Menu Coax option
A3-26
This section describes the Coax option available at the control
panel and how you may set them.
Once the physical components of the interface are connected
and the XES emulation has been set up, the XCTO may need to
be set up, or configured to meet the needs of your office.
configuration options are set through the IBM Main Menu.
Note: The factory defaults refer to those defaults in place when
the interface is first installed.
defaults to meet your particular needs.
in effect each time the system is switched on.
The menu is accessed from the printer control panel.
By configuring the interface, you are establishing your own
default settings. There are two types of changes to the interface
configuration.
Permanent settings which remain unchanged even through a
•
power off/on cycle.
Temporary settings which remain current until a software
•
command to change the setting is received, or the printer is
switched off.
The options available for IBM Coax interface are:
IBM buttons
•
Coax configuration
•
—Page configuration
—Data Stream Compatibility (DSC) configuration
—Language
—Special features
You can change the factory
Defaults are the settings
XEROX 4213 LASER PRINTER USER GUIDE
The