Setting Different Options Under The Ibm Main Menu For Twinax A3-67 - Xerox 4213 User Manual

Setting different options under the IBM Main Menu for Twinax
XEROX 4213 LASER PRINTER USER GUIDE
D 11. When the password entry is completed, press the Select
button. The display should reads:
IBM COMMS
COAX*
C 12. Press the Last Page. The display reads:
IBM COMMS
TWINAX
D 13. Press the Select button to select the Twinax communications
option.
You may immediately use the IBM Twinax interface by following
the final step below.
H
14. Press the Online button to take the printer online. This step
is necessary to initialise the Twinax option. The green online
indicator light is lit and the 4213 is ready and the IBM Twinax
interface is in place.
Note: Initialising the Twinax option by pressing the online
button to put the 4213 back online will restart the host
communication and reload the configuration option with Twinax
configuration defaults.
H 15. Press the Online button to take the printer off line to re-
configure the Twinax option, if required.
indicator light is not lit.
Notes The Twinax configuration sheet will not print unless the
•
Coax/Twinax host interface is selected and activated.
If you wish to change any of the IBM Twinax interface
•
configuration options, proceed to "Changing the IBM Twinax
Configuration" section. If you wish the IBM Twinax interface
to be in place each time the 4213 is switched on, proceed
directly to "Saving the IBM Twinax configuration" section.
To change the IBM Twinax interface configuration, follow steps 1
to 7 in the previous section to access the IBM Main Menu
heading.
B Use the Test button to move to the next lower menu
•
level.
XEROX COAX/TWINAX OPTION
The green online
A3-67