Install Additional Options; System Controller Board Reinstallation; Simm Board Removal And Replacement Procedures; Before You Begin - Xerox 4213 User Manual

SIMM KIT INSTALLATION AND REMOVAL INSTRUCTIONS

System controller board reinstallation

SIMM board removal and replacement procedures

Before you begin

A5-8

Install additional options

If you purchased additional options for your printer, you can
install them at this time while the system controller board is out
of the printer. If there are no additional options to be installed,
continue with step 13.
13. Place the system controller board into the receiving rails of
the printer.
14. For reinstallation of the system controller board, reverse the
removal process in steps 1 to 6.
Caution: Cable
reinstallation of the system controller board; therefore, route
them carefully.
When an error message on the message display shows that a
SIMM board is faulty, use the following steps to remove or
replace one or all of the boards.
Perform the following steps before beginning the SIMM board
removal and replacement procedures (refer to figure A5-8).
connectors may interfere
4213 LASER PRINTER USER GUIDE
with the