Installation procedures
System controller board removal
4213 LASER PRINTER USER GUIDE
SIMM KIT INSTALLATION AND REMOVAL INSTRUCTIONS
The following steps guide you through the removal of the system
controller board, the installation of the SIMM board(s), and the
reinstallation of the system controller board.
1. Locate the two thumb screws on the system controller
access cover plate. (Refer to figure A5-2 for location of this
plate.)
For steps 2 to 7, refer to figure A5-3.
Figure A5-3.
System controller board
1. Thumbscrews
2. System controller access cover plate
3. Cable connector J7
4. Cable connector J2
5. SIMM connectors J15-J11
A5-3