System Information And Statistics Commands; Show Arp Switch; Show Eventlog; Show Hardware - Ubiquiti EDGESWITCH ES-24-250W Command Reference Manual

EdgeSwitch CLI Command Reference

System Information and Statistics Commands

This section describes the commands you use to view information about system features, components, and
configurations .

show arp switch

This command displays the contents of the IP stack's Address Resolution Protocol (ARP) table . The IP stack only
learns ARP entries associated with the management interfaces – network or service ports . ARP entries associated
with routing interfaces are not listed .
show arp switch
Format
Mode Privileged EXEC
Term
IP Address
MAC Address
Interface

show eventlog

This command displays the event log, which contains error messages from the system . The event log is not
cleared on a system reset . The unit is the switch identifier .
show eventlog [unit]
Format
Mode
Privileged EXEC
Term
File
Line
Task Id
Code
Time
Unit
Note: Event log information is retained across a switch reset .

show hardware

This command displays inventory information for the switch .
show version
Note: The
information . In future releases of the software, the
a description of the command output, see the command "show version" on page 108 .
show hardware
Format
Mode Privileged EXEC
Ubiquiti Networks, Inc.
Definition
IP address of the management interface or another device on the management network.
Hardware MAC address of that device.
For a service port the output is Management. For a network port, the output is the slot/port of the
physical interface.
Definition
The file in which the event originated.
The line number of the event.
The task ID of the event.
The event code.
The time this event occurred.
The unit for the event.
command and the
show hardware
command display the same
show hardware
command will not be available . For
Utility Commands
107