Displaying Connection Status; Figure 25: Configuring Connections By Port Range - Edge-Core ECS4810-12M Layer 2 Management Manual

Hide thumbs Also See for ECS4810-12M Layer 2:

Table of Contents

Click Apply.

Use the Interface > Port > General (Show Information) page to display the

current connection status, including link state, speed/duplex mode, flow

control, and auto-negotiation.

"show interfaces status" on page 838

These parameters are displayed:

Port – Port identifier.

Type – Indicates the port type. (100Base SFP, 1000Base-T,

1000Base SFP)

Name – Interface label.

Admin – Shows if the port is enabled or disabled.

Oper Status – Indicates if the link is Up or Down.

Media Type – Media type used.

(Options: RJ-45 – Copper-Forced;

Combination – Copper-Forced, SFP-Forced, or SFP-Preferred-Auto;

Default: RJ-45 – Copper-Forced; Combination – SFP-Preferred-Auto)

Autonegotiation – Shows if auto-negotiation is enabled or disabled.

Oper Speed Duplex – Shows the current speed and duplex mode.

Oper Flow Control – Shows the flow control type used.

| Interface Configuration

Port Configuration

Troubleshooting