Edge-Core ECS4810-12M Layer 2 Management Manual page 99

Table 6: Switch Main Menu (Continued)
Menu
Show Remote MEP Details
Show Link Trace Cache
Show Fault Notification Generator
Show Continuity Check Error
OAM
Interface
Counters
Event Log
Remote Interface
Remote Loopback
IP
General
Ping
ARP
Configure General
Show Information
IPv6 Configuration
Configure Global
Configure Interface
Add IPv6 Address
Show IPv6 Address
Show IPv6 Neighbor Cache
Show Statistics
IPv6
ICMPv6
UDP
Show MTU
IP Service
DNS
General
Configure Global
Description
Displays detailed CFM information about a specified remote MEP in
the continuity check database
Shows information about link trace operations launched from this
device
Displays configuration settings for the fault notification generator
Displays CFM continuity check errors logged on this device
Operation, Administration, and Maintenance
Enables OAM on specified port, sets the mode to active or passive,
and enables the reporting of critical events or errored frame events
Displays statistics on OAM PDUs
Displays the log for recorded link events
Displays information about attached OAM-enabled devices
Performs a loopback test on the specified port
Sends ICMP echo request packets to another node on the network
Address Resolution Protocol
Sets the protocol timeout, and enables or disables proxy ARP for
the specified VLAN
Shows dynamically learned entries in the IP routing table
Sets an IPv6 default gateway for traffic with no known next hop
Configures IPv6 interface address using auto-configuration or link-
local address, and sets related protocol settings
Adds an global unicast, EUI-64, or link-local IPv6 address to an
interface
Show the IPv6 addresses assigned to an interface
Displays information in the IPv6 neighbor discovery cache
Shows statistics about IPv6 traffic
Shows statistics about ICMPv6 messages
Shows statistics about UDP messages
Shows the maximum transmission unit (MTU) cache for
destinations that have returned an ICMP packet-too-big message
along with an acceptable MTU to this switch
Domain Name Service
Enables DNS lookup; defines the default domain name appended
to incomplete host names
– 99 –
| Using the Web Interface
C 3
HAPTER
Navigating the Web Browser Interface
Page
480
482
483
484
486
486
488
489
490
491
495
495
496
497
498
503
503
504
507
510
512
513
513
513
513
519
521
521
521