Table of Contents
Advertisement
auto-traffic-control
alarm-clear-
threshold
E
XAMPLE
This example sets the control response for broadcast traffic on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast action shutdown
Console(config-if)#
This command sets the lower threshold for ingress traffic beneath which a
control response for rate limiting will be released after the Release Timer
expires, if so configured by the
command. Use the no form to restore the default setting.
S
YNTAX
auto-traffic-control {broadcast | multicast}
alarm-clear-threshold threshold
no auto-traffic-control {broadcast | multicast}
alarm-clear-threshold
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
threshold - The lower threshold for ingress traffic beneath which a
cleared storm control trap is sent. (Range: 1-255 kilo-packets per
second)
D
S
EFAULT
ETTING
128 kilo-packets per second
C
M
OMMAND
ODE
Interface Configuration (Ethernet)
C
U
OMMAND
SAGE
Once the traffic rate falls beneath the lower threshold, a trap message
◆
may be sent if configured by the
broadcast-alarm-clear
multicast-alarm-clear
◆
If rate limiting has been configured as a control response, it will be
discontinued after the traffic rate has fallen beneath the lower
threshold, and the release timer has expired. Note that if a port has
been shut down by a control response, it will not be re-enabled by
automatic traffic control. It can only be manually re-enabled using the
auto-traffic-control control-release
– 875 –
| Automatic Traffic Control Commands
C
32
HAPTER
auto-traffic-control auto-control-release
snmp-server enable port-traps atc
command or
snmp-server enable port-traps atc
command.
command.
Advertisement
Table of Contents
Troubleshooting
