Displaying Details For Remote Meps - Edge-Core ECS4810-12M Layer 2 Management Manual

Hide thumbs Also See for ECS4810-12M Layer 2:

Table of Contents

| Basic Administration Protocols

Connectivity Fault Management

Use the Administration > CFM > Show Information (Show Remote MEP

Details) page to show detailed information for MEPs located on other

devices which have been discovered through continuity check messages, or

statically configured in the MEP database and verified through cross-check

"show ethernet cfm maintenance-points remote detail" on page 1111

These parameters are displayed:

MD Index – Domain index. (Range: 1-65535)

MA Index – MA identifier. (Range: 0-4094)

MEP ID – Maintenance end point identifier. (Range: 1-8191)

MD Name – Maintenance domain name.

MA Name – Maintenance association name.

Level – Authorized maintenance level for this domain.

MAC Address – MAC address of this MEP entry.

Primary VLAN – Service VLAN ID.

Incoming Port – Port to which this remote MEP is attached.

CC Lifetime – Length of time to hold messages about this MEP in the

CCM database.

Age of Last CC Message – Length of time the last CCM message

about this MEP has been in the CCM database.

Frame Loss – Percentage of transmitted frames lost.

CC Packet Statistics – The number of CCM packets received

successfully and those with errors.

Port State – Port states include:

Up – The port is functioning normally.

Blocked – The port has been blocked by the Spanning Tree Protocol.

No port state – Either no CCM has been received, or nor port status

TLV was received in the last CCM.

Interface State – Interface states include:

No Status – Either no CCM has been received, or no interface status

TLV was received in the last CCM.

Up – The interface is ready to pass packets.

Troubleshooting