Table of Contents
Advertisement
Table 24: Logging Levels (Continued)
Level
Severity Name
1
Alert
0
Emergency
* There are only Level 2, 5 and 6 error messages for the current firmware release.
RAM Level – Limits log messages saved to the switch's temporary RAM
◆
memory for all levels up to the specified level. For example, if level 7 is
specified, all messages from level 0 to level 7 will be logged to RAM.
(Range: 0-7, Default: 7)
The Flash Level must be equal to or less than the RAM Level.
N
:
OTE
All log messages are retained in RAM and Flash after a warm restart
N
:
OTE
(i.e., power is reset through the command interface).
All log messages are retained in Flash and purged from RAM after a
N
:
OTE
cold restart (i.e., power is turned off and then on through the power
source).
W
I
EB
NTERFACE
To configure the logging of error messages to system memory:
Click Administration, Log, System.
1.
Select Configure Global from the Step list.
2.
Enable or disable system logging, set the level of event messages to be
3.
logged to flash memory and RAM.
Click Apply.
4.
Figure 210: Configuring Settings for System Memory Logs
– 381 –
| Basic Administration Protocols
C
15
HAPTER
Configuring Event Logging
Description
Immediate action needed
System unusable
Advertisement
Table of Contents
Troubleshooting
