Cluster Member - Edge-Core ECS4810-12M Layer 2 Management Manual

Hide thumbs Also See for ECS4810-12M Layer 2:

Table of Contents

| System Management Commands

Switch Clustering

cluster member

An "internal" IP address pool is used to assign IP addresses to Member

switches in the cluster. Internal cluster IP addresses are in the form

10.x.x.member-ID. Only the base IP address of the pool needs to be

set since Member IDs can only be between 1 and 36.

Set a Cluster IP Pool that does not conflict with addresses in the

network IP subnet. Cluster IP addresses are assigned to switches when

they become Members and are used for communication between

Member switches and the Commander.

You cannot change the cluster IP pool when the switch is currently in

Commander mode. Commander mode must first be disabled.

Console(config)#cluster ip-pool 10.2.3.4

Console(config)#

This command configures a Candidate switch as a cluster Member. Use the

no form to remove a Member switch from the cluster.

cluster member mac-address mac-address id member-id

no cluster member id member-id

mac-address - The MAC address of the Candidate switch.

member-id - The ID number to assign to the Member switch.

(Range: 1-36)

Global Configuration

The maximum number of cluster Members is 36.

The maximum number of cluster Candidates is 100.

Console(config)#cluster member mac-address 00-12-34-56-78-9a id 5

Console(config)#