Configuring A Class Map - Edge-Core ECS4810-12M Layer 2 Management Manual

Hide thumbs Also See for ECS4810-12M Layer 2:

Table of Contents

| Quality of Service

Configuring a Class Map

ONFIGURING A

To create a service policy for a specific category or ingress traffic, follow

these steps:

Use the Configure Class (Add) page to designate a class name for a

specific category of traffic.

Use the Configure Class (Add Rule) page to edit the rules for each class

which specify a type of traffic based on an access list, a DSCP or IP

Precedence value, a VLAN, a CoS value, or a source port.

Use the Configure Policy (Add) page to designate a policy name for a

specific manner in which ingress traffic will be handled.

Use the Configure Policy (Add Rule) page to add one or more classes to

the policy map. Assign policy rules to each class by "setting" the QoS

value (CoS or PHB) to be assigned to the matching traffic class. The

policy rule can also be configured to monitor the maximum throughput

and burst rate. Then specify the action to take for conforming traffic, or

the action to take for a policy violation.

Use the Configure Interface page to assign a policy map to a specific

A class map is used for matching packets to a specified class. Use the

Traffic > DiffServ (Configure Class) page to configure a class map.

"Quality of Service Commands" on page 987

The class map is used with a policy map

271) for a specific interface that defines packet

classification, service tagging, and bandwidth policing. Note that one or

more class maps can be assigned to a policy map.

Up to 32 class maps can be configured.

These parameters are displayed:

Class Name – Name of the class map. (Range: 1-16 characters)

Type – The criteria specified by the match command.

Match All – Match all conditions within a class map.

Match Any – Match any condition within a class map.

262) to create a service