Show Network-Access Mac-Address-Table - Edge-Core ECS4810-12M Layer 2 Management Manual

| General Security Measures
C 26
HAPTER
Network Access (MAC Address Authentication)
show network-
access mac-
address-table
E
XAMPLE
Console#show network-access interface ethernet 1/1
Global secure port information
Reauthentication Time
MAC address Aging
Port : 1/1
MAC Authentication
MAC Authentication Intrusion action
MAC Authentication Maximum MAC Counts : 1024
Maximum MAC Counts
Dynamic VLAN Assignment
Dynamic QoS Assignment
MAC Filter ID
Guest VLAN
Link Detection
Detection Mode
Detection Action
Console#
Use this command to display secure MAC address table entries.
S
YNTAX
show network-access mac-address-table [static | dynamic]
[address mac-address [mask]] [interface interface]
[sort {address | interface}]
static - Specifies static address entries.
dynamic - Specifies dynamic address entries.
mac-address - Specifies a MAC address entry.
(Format: xx-xx-xx-xx-xx-xx)
mask - Specifies a MAC address bit mask for filtering displayed
addresses.
interface - Specifies a port interface.
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
sort - Sorts displayed entries by either MAC address or interface.
D S
EFAULT ETTING
Displays all filters.
C M
OMMAND ODE
Privileged Exec
C U
OMMAND SAGE
When using a bit mask to filter displayed MAC addresses, a 1 means "care"
and a 0 means "don't care". For example, a MAC of 00-00-01-02-03-04 and
mask FF-FF-FF-00-00-00 would result in all MACs in the range 00-00-01-
– 762 –
: 1800
: Enabled
: Disabled
: Block traffic
: 2048
: Enabled
: Disabled
: Disabled
: Disabled
: Disabled
: Link-down
: Trap