Configuring Port Link Detection; Figure 162: Configuring Interface Settings For Network Access - Edge-Core ECS4810-12M Layer 2 Management Manual

| Security Measures
C 14
HAPTER
Network Access (MAC Address Authentication)
C P
ONFIGURING ORT
L D
INK ETECTION

Figure 162: Configuring Interface Settings for Network Access

Use the Security > Network Access (Configure Interface - Link Detection)
page to send an SNMP trap and/or shut down a port when a link event
occurs.
CLI R
EFERENCES
"Network Access (MAC Address Authentication)" on page 750
◆
P
ARAMETERS
These parameters are displayed:
◆ Link Detection Status – Configures whether Link Detection is enabled
or disabled for a port.
Condition – The link event type which will trigger the port action.
◆
Link up – Only link up events will trigger the port action.
■
Link down – Only link down events will trigger the port action.
■
Link up and down – All link up and link down events will trigger
■
the port action.
Action – The switch can respond in three ways to a link up or down
◆
trigger event.
Trap – An SNMP trap is sent.
■
Trap and shutdown – An SNMP trap is sent and the port is shut
■
down.
Shutdown – The port is shut down.
■
– 306 –