Dot1X Pae Supplicant - Edge-Core ECS4810-12M Layer 2 Management Manual

Hide thumbs Also See for ECS4810-12M Layer 2:

Table of Contents

Console(config)#interface eth 1/2

Console(config-if)#dot1x max-start 10

Console(config-if)#

This command enables dot1x supplicant mode on a port. Use the no form

to disable dot1x supplicant mode on a port.

[no] dot1x pae supplicant

Interface Configuration

When devices attached to a port must submit requests to another

authenticator on the network, configure the identity profile parameters

dot1x identity profile

switch as a supplicant, and enable dot1x supplicant mode for those

ports which must authenticate clients through a remote authenticator

using this command. In this mode the port will not respond to dot1x

messages meant for an authenticator.

This switch can be configured to serve as the authenticator on selected

ports by setting the control mode to "auto" (see the

setting the control mode to "force-authorized" and enabling dot1x

supplicant mode with this command.

A port cannot be configured as a dot1x supplicant if it is a member of a

trunk or LACP is enabled on the port.

Console(config)#interface ethernet 1/2

Console(config-if)#dot1x pae supplicant

Console(config-if)#

732), and as a supplicant on other ports by the

| Authentication Commands

802.1X Port Authentication

736) which identify this

dot1x port-control

Troubleshooting