Table of Contents
Advertisement
To configure GVRP status and timers on a port or trunk:
Click VLAN, Dynamic.
1.
Select Configure Interface from the Step list.
2.
Set the Interface type to display as Port or Trunk.
3.
Modify the GVRP status or timers for any interface.
4.
Click Apply.
5.
Figure 71: Configuring GVRP for an Interface
To show the dynamic VLAN joined by this switch:
Click VLAN, Dynamic.
1.
Select Show Dynamic VLAN from the Step list.
2.
Select Show VLAN from the Action list.
3.
Figure 72: Showing Dynamic VLANs Registered on the Switch
– 187 –
| VLAN Configuration
C
6
HAPTER
IEEE 802.1Q VLANs
Advertisement
Table of Contents
Troubleshooting
